Property Damage - InSinkErator WASH-1 Manuel D'installation, D'entretien Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Figure 1 – Typical
Installation
Shown
Note: Tank must be
located within 16"
(40 cm) of faucet and
within 30" (75 cm)
or less of a standard
grounded outlet.
DO NOT extend
plumbing or
electrical lines.
*Filtration system is optional
NOTICE

PROPERTY DAMAGE

Do not plug in the water tank until step 6-B.
To avoid permanent damage to the product,
only operate the tank after it is filled with water.
Faucet
Overview of Complete Set-up
*
Components In This Package
3/4" (2 cm) Screws (2)
Lock
Metal
Mounting Plate
Washer
A minimum of 2" (5 cm)
of space is required
from the center of the
faucet head to the
back wall in order
for this appliance to
operate properly.
A standard 120-volt
GFCI outlet is required
under the sink for the
unit's electrical power.
Hex Nut
Snap-Connect
Fitting (3 pieces)
Tank
5
2"
(5 cm)
Base Plate
(Optional)

Publicité

Table des Matières
loading

Table des Matières