Preparation; Installing The Faucet - InSinkErator WASH-1 Manuel D'installation, D'entretien Et D'utilisation

1. PREPARATION

A
Required minimum from
center of hole to wall
2" (51 mm)
Maximum counter
thickness (depth)
1½" (38 mm)
Identify locations for the faucet and tank.
Check to make sure there is proper clearance for
faucet handle to be fully opened.
Check to make sure counter is not too thick.
Make sure there is a GFCI outlet under the sink.
The wall outlet for your faucet must have power
supplied to it continuously and must be fused. It should not
be controlled by the same wall switch that operates
a food waste disposer.
B
Turn off water supply.
C
Required Hole Diameter
1¼" (32 mm) - 1½" (38 mm)
Consult a professional before drilling into
a surface other than stainless steel.
If drilling a hole into a stainless steel sink or counter
top, you can cut a mounting hole for the faucet with
a hole saw for stainless steel, or you can use a hole
punch.
Installation
Proper installation should take 2-4 hours.
7

2. INSTALLING THE FAUCET

NOTICE
PROPERTY DAMAGE
• Do not pinch or break copper tubing.
• Do not distort the last 1" (25 mm) of tubing.
A
Unpack faucet components.
On a firm, flat surface, carefully straighten the
copper tubing.
B
Feed tubes down into hole until faucet rests on
deck plate (see illustration).
From under the sink, place the metal mounting
plate onto the threaded stud.
C
Make sure faucet head is at the desired angle.
Place the supplied lock washer and hex nut on
to the threaded stud.
Tighten to secure the faucet to the sink top.
Do not over tighten.