Restoring Factory Default Settings - IKEA ADRATT 904.620.39 Mode D'emploi

OVEN CONTROLS
Adjusting Oven Temperatures
Your appliance has been factory calibrated and
tested to ensure accurate baking temperatures.
For the fi rst few uses, follow your recipe times and
temperature recommendations carefully. If you
think the oven is cooking too hot or too cool for
your recipe times, you may adjust the control so the
oven cooks hotter or cooler than the oven tempera-
ture displayed.
NOTE: Do not use oven thermometers such as those
found in grocery stores to check the temperature
settings inside your oven. These oven thermometers
may vary as much as 20 to 40°F degrees from actual
temperatures.
The oven temperature may be increased as much
as +35°F (+19°C) or decreased -35°F (-19°C) from
the factory calibrated settings.
To increase or decrease the oven temperature
by 20°F:
1. Press and hold Bake until the control produces
an audible tone (about 6 seconds). The factory
offset temperature of 0 (zero) should appear in
the display.
2. Enter 2 0 using numeric keypad.
3. To offset the oven by -20°F, press self clean to
toggle between + and -.
4. Press OK/START to accept change.
IMPORTANT
Oven temperature adjustments will not change
the Broil, Self Clean, or Keep Warm temperatures.
The oven temperature adjustment may be made
if your oven control is set to display temperatures
in °C (Celsius). Minimum and maximum settings
for Celsius range from plus (+)19°C to minus (-)
19°C.If Steam Clean results are not satisfactory,
run a Self Clean.
32

Restoring Factory Default Settings

Your appliance was set with predetermined (default)
oven control settings. Over time, users may have
made changes to these settings. The following op-
tions may have been modifi ed since the appliance
was new:
• 12 or 24 hr display mode
• All Meat Probe settings
• Continuous bake or 12 hour energy savings
mode
• Silent or audible control
• Oven temperature display
(Fahrenheit or Celsius)
• Oven temperature adjustments (UPO)
NOTE
ALL of the above user settings will be restored to
the factory default settings.
To restore oven control to factory default
settings:
Press and hold 7 on numeric keypad until acceptance
tone sounds (about 6 seconds).
Press OK/START. The control has been reset with
the default settings.
EN