IKEA ADRATT 904.620.39 Mode D'emploi page 26

OVEN CONTROLS
To set how the oven will operate once the
probe reaches the target temperature:
The oven is preset to automatically stop cooking and
start the warm feature when probe sensor reaches
the target temperature. This may be set to continue
cooking if desired. Setting the options must be done
when the oven is inactive. The probe is not required
to be connected to the probe receptacle when set-
ting this option.
To set the oven to continue cooking after reaching
the target temperature:
1. Press probe key and hold for 6 seconds.
2. Press Self Clean key and toggle until Continu:
appears, as shown, then press OK/START to
accept.
To set the oven to automatically stop cooking
and start warm once reaching target tempera-
ture:
1. Press probe key and hold for 6 seconds.
2. Press the Self Clean key and toggle until
CAnCEL appears, as shown, then press OK/
START to accept.
Probe too hot message:
When the message Prob... Too... Hot... fl ashes in
the display, the probe temperature has exceeded
250°F (121°C).
If the probe is not removed, this message may
continue until the sensor reaches 300°F (149°C) or
higher, and oven will automatically turn off. Be sure
the probe sensor is fully covered by the food.
26
Warm
Warm should only be used with foods that are
already at serving temperatures. Warm will keep
cooked foods warm and ready for serving for up to
3 hours after cooking has fi nished. After 3 hours the
keep warm will shut-off automatically. Keep warm
will keep the oven temperature at 170° F (77°C).
To set Warm:
1. If needed, arrange oven racks and place cooked
food in oven.
2. Press Warm: WARM will appear in the display.
(If no other keys are touched within 25 seconds
the request for keep warm will clear.)
3. Press OK/START. Keep Warm will automatically
turn on and then turn off after 3 hours unless
cancelled.
WARNING
Food poisoning hazard. Do not let food sit for more
than one hour before or after cooking. Doing so
can result in food poisoning or sickness.
To add Warm to turn ON after baking 45 min-
utes with a set temperature of 425°F:
1. Press Bake Time.
2. Enter 45 using numeric keypad.
3. Press OK/START.
4. Press Bake and enter 425 on numeric keypad.
5. Press OK/START to accept.
6. Press Warm. WARM will appear in the display.
7. Press OK/START. When the bake time is over,
Keep Warm will automatically turn ON. The Keep
Warm function will automatically turn OFF after
3 hours.
NOTE
Warm will maintain the oven temperature at 170°
F (77°C) for 3 hours. Warm may be set when fi n-
ished cooking.
EN