INFOSEC M5T Manuel Utilisateur page 115

To access the "Advance➔Maintainer" Setting menu page, it's required to enter password.
Please contact your local dealer to get maintainer password.
CAUTION: This setting menu is only for qualified technician. Otherwise, mis-operation will
cause UPS damage.
There are nine sub-menus under "Advance➔Maintainer" setting: SYS PARAMETER,
INSTALL INFO, VOL CALI, CURR CALI, INITIAL, ELECTRONIC, BATT, MISCELLANEOUS
and UPS SELFTEST.
SYS PARAMETER
➢
Mode Name: Set the UPS model name.
➢
Serial Number: Set the serial number.
➢
Manufacturer: Set the UPS manufacturer.
➢
Charger Number: The number of charging boards installed in the UPS.
NOTE: It's required to restart the UPS after setting.
➢
Max Charge CURR:
◼
One piece of charger: There are twelve options: 1A, 2A, 3A, 4A, 5A, 6A, 7A, 8A, 9A,
10A, 11A, 12A.
◼
Two pieces of charger: There are twelve options: 2A, 4A, 6A, 8A, 10A, 12A, 14A,
16A, 18A, 20A, 22A, 24A
➢ BATT Number: The total number of installed battery. (It's required to restart the UPS
INFOSEC UPS SYSTEM – 15, rue du Moulin – 44880 Sautron, France – www.infosec-ups.com
114
Hotline : +33 (0)2 40 76 15 82 – Fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 02 22 AA 59 203 08
Advance: Maintainer Setting Menu Page 2
SYS PARAMETER Page 1