Milwaukee M18 FUEL Manuel De L'utilisateur page 7

10. Remove motor housing and pour liquid waste into
a suitable drain.
11. Clean the interior of the tank and pick-up acces-
sories periodically, more often when used to pick
up wet, sticky materials. Use warm, soapy water.
Do not store vacuum with liquid in tank.
Automatic Suction Shut-Off
When picking up liquids, an internal float rises until it
seats itself against a seal at the intake of the motor,
shutting off suction. When this happens, the motor
will develop a higher than normal pitch noise and the
suction is drastically reduced. If this occurs, turn off
the vacuum immediately.
NOTICE
Failure to turn off unit after float
rises and shuts off suction will re-
sult in damage to the motor.
To continue use, empty the liquid waste from the tank.
If the vacuum is accidentally tipped over, it could lose
suction. Turn off the vacuum and return it to an upright
position. The float will return to its normal position.
Installing/Removing Fleece Dust Bag
For increased filter life and ease of cleanup, use
a fleece dust bag to collect fine dust particles
(Single pack, Cat. No. 49-90-1979).
1. To install, release the tank latches and remove
the motor housing.
2. Lift the dust bag holder up and out to remove
from the tank.
3. Slide the cardboard dust bag inlet in to the dust
bag holder.
4. Insert the dust bag holder back into the slot push-
ing downward to secure in place.
5. Spread out the dust bag in the tank. Replace the
motor housing and secure both latches.
6. To remove, release the tank latches and remove
motor housing.
7. Lift the dust bag holder up and out to remove
from the tank.
8. Slide the dust bag holder off the dust bag.
9. Pull the cardboard tab until the dust bag inlet
is closed. Dust bag is now sealed and can be
properly disposed.
Replace fleece dust bag once the bag is at full ca-
pacity, suction decreases or dust bag is damaged.
Before storing your vacuum, empty and clean the
tank, filter, and accessories. Remove the battery pack.
MAINTENANCE
WARNING
the charger and remove the battery pack from
the charger or tool before performing any main-
tenance. Never disassemble the tool, battery
pack or charger. Contact a MILWAUKEE service
facility for ALL repairs.
Never use vacuum without tank and filter properly
installed.
Maintaining the Filters
Keep filter clean. Clean the filter by twisting the filter
cover counter-clockwise to unlock from the motor
housing/float cage. Pull the filter away from the
vacuum. Empty debris by holding away from the
user's face and tap clean. Water may be used to
clean the filter.
If cleaning high efficiency filters with water, let filter
dry 24 hours before using with vacuum. Replace filter
if damaged or suction decreases (Dry filters single
pack, Cat. No. 49-90-1977, 49-90-1978 or Wet filter
single pack Cat. No. 49-90-1990).
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage of
parts, or any other condition that may affect the tool
operation. Return the tool, battery pack, and charger
to a MILWAUKEE service facility for repair. After six
months to one year, depending on use, return the
tool, battery pack and charger to a MILWAUKEE
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work prop-
erly, return the tool, charger and battery pack, to a
MILWAUKEE service facility for repairs.
7
Storage
To reduce the risk of
injury, always unplug