Milwaukee M18 FUEL Manuel De L'utilisateur page 5

ASSEMBLY
WARNING
the battery pack before removing the tank.
CAUTION
dependent on the filter. A dirty filter will reduce
the air flow and overall efficiency of the system.
Remove from tank and tap clean.
WARNING
the battery. For specific charging instructions,
read the operator's manual supplied with your
charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Removing/Installing the Filters
Use the high efficiency filter for dry pickup only. Use
the foam filter for wet pick-up operation only.
1. Remove the battery pack.
2. Release the tank latches and lift off the motor
housing. Place it upside down on a flat surface.
3. To remove the filter, turn it 1/2" counter clockwise
and pull it off of the motor housing/float cage.
4. Empty all debris from the tank.
NOTICE
jobsite guidelines pertaining to
the disposal of silica dust.
5. To install the filter, slide it over the float cage. Line
up the filter tabs with the motor housing notches
and turn it 1/2" clockwise to lock in place.
6. Replace the motor housing and secure both
latches.
WARNING
glasses and a dust mask when using the vacuum
cleaner as a blower. Clean tank completely before
use.
Pick-Up/Blower
The vacuum can be used for debris pick-up or as a
blower, depending on the port used.
1. For the debris pick-up, insert the large end of the
hose into the intake port of the motor housing, lin-
ing up the tabs on the hose with the notches in the
port. Twist to secure and form a tight fit.
To reduce the risk of
injury, always remove
Keep filter clean. Efficiency
of the vacuum is largely
Recharge only with the
charger specified for
Always remove the bat-
tery pack any time the
When applicable, adhere to
To reduce the risk of
injury: wear safety
2. To use as a blower, insert the large end of hose
into the blower port
up the tabs on the hose with the notches in the
port. Twist to secure and form a tight fit.
WARNING
mended for this tool. Others may be hazardous.
Attaching/Removing the Wet/Dry
Vacuum Cart
1. To attach, place rear of vacuum on the cart with
the front angled upwards.The vacuum inlet should
face the front of the cart where the pedal is located.
2. Slide the rear of the vacuum under the ledge feature.
Ledge
Feature
3. Lower the front of the vacuum so it lines up with
the cart and front ledge. Once the cart clicks, the
vacuum is secured on the cart.
5
of the motor housing, lining
Only use accessories
specifically recom-