Milwaukee M18 FUEL Manuel De L'utilisateur page 6

4. To remove, press one foot on the pedal. Lift the
vacuum with handle away from the cart.
Installing/Removing the Hose
To install the hose, line up notches on the hose
with the vacuum inlet. Push in and twist toward lock
to secure in place.
To remove the hose, twist the hose towards the un-
lock and pull away from vacuum inlet.
Installing/Removing the Accessories
To install the nozzles, or extensions, push the ac-
cessory onto the vacuum hose until it clips in place.
To remove the accessory, open hose clip and pull
the accessory off the vacuum hose. Store the ac-
cessories in the motor head or in the designated
cart storage areas.
Installing/Removing the Dust Extraction
(Cat. No. 49-90-1980, not included)
The dust extractor hose adapter is used to connect
the hose to a power tool in place of other dust col-
lection, such as a dust bag.
To install the adapter, remove any nozzles or acces-
sories from the end of the hose. Twist the adapter
onto the hose until tight for a secure fit.
To remove, reverse the procedure.
Installing/Removing the Accessory
Storage Bag
(Cat. No. 49-90-2019, not included)
1. To install, ensure the top of the motor housing is clear.
2. Place the accessory storage bag on top of the
motor housing with the logo facing up.
3. Locate the hooks on the accessory storage bag
and attach them to the storage tie downs on the
motor housing. NOTE: There are 2 storage tie
downs on each side of motor housing with a total
of 4 storage tie downs.
Adapter
4. To remove, unhook the accessory storage bag
from the motor housing and remove the acces-
sory storage bag.
OPERATION
WARNING
proper eye protection marked to comply with
ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
To reduce the risk of fire and injury, do not use
to pick up flammable or combustible materials.
Before use, ensure the filter and float cage are
properly installed. Remove dry filter before all
wet pick-up operations.
Starting and Stopping Vacuum
To turn the vacuum on max run-time mode, push
the switch to the Speed One (I) position.
To turn the vacuum on max power mode, push the
switch to the Speed Two (II) position.
To turn off the vacuum, push the switch to the OFF
(O) position.
CAUTION
does not shut off when the tank is filled, contact
a MILWAUKEE service facility for repairs. A mal-
functioning tool can cause personal injury or
property damage.
Wet Pick-Up Operation
For wet pick-up operation, it is recommended to use
the foam filter (Single pack, Cat. No. 49-90-1990).
1. Remove the battery pack.
2. Remove ALL dirt and debris found in the tank.
3. Remove the high efficiency filter and install the
foam filter (see "Removing/Installing the Filter").
Ensure that the float cage remains in place.
4. A float cage shuts off suction when the tank is full.
Be sure that the float is clean and moves freely in
the float cage to ensure that the float valve works.
5. Insert the battery pack.
6. Turn on the vacuum and begin pick-up.
7. Turn off the vacuum immediately upon completing
a wet pick-up job or when tank is full and ready to
be emptied. If suction shuts off, turn off the vacuum
immediately and empty the tank.
8. Remove the battery pack.
9. To empty the tank, raise the hose to drain any
excess liquid into the tank. Do not use vacuum
inlet to drain contents.
6
To reduce the risk of
injury, always wear
If the float is clean, moves
freely, and the suction
Float Cage