Travelling; Clothing; Baby Sound And Video Monitors; Settings - Snuza HERO Notice D'utilisation

7.3 Travelling

Movement from external sources such as being pushed in a pram or travelling in a
vehicle or aircraft may be detected by Hero's sensor. Hero should not be relied upon
where external sources of movement are present.

7.4 Clothing

• Hero can be clipped onto the folded waistband of the diaper or the waistband of
elasticated pants, as long as the Movement Sensor (1) touches the baby in the
tummy area.
• There may also be a thin layer of clothing (eg a vest) between the Sensor and the
skin, but ensure that the Sensor maintains contact.
• The monitor can also be used if baby is dressed in light clothing (for example, a
Babygro) over the nappy or pants to which the Hero is attached.
• Too much clothing may attenuate or muffle the alarm. Make sure the alarm can be
heard if baby is covered in clothing and/or blankets.
7.5 Baby Sound and Video Monitors (Optional)
Hero can be used together with a baby sound or video monitor to extend the distance at
which the alarm can be heard.

8. SETTINGS

8.1 Audible Tick

This feature causes Hero to emit an audible 'tick' on each movement. To enable the
Audible tick, ensure that Hero is switched ON, and press the MODE/OFF button (7)
briefly (less than 1 second). To increase the volume of the tick, press the MODE/OFF
button once again for medium volume and again for high volume.
To turn off, briefly press the MODE/OFF button a fourth time – Hero will give a louder
beep.
The alarm can be deactivated by briefly pressing the
MODE/OFF button (7) or by turning Hero off
completely (press ON/OFF (6) and MODE/OFF (7) buttons
simultaneously). If the MODE/OFF button is used to
deactivate the alarm, monitoring will continue.
9