Fitting Your Hero; Operation; Startup - Snuza HERO Notice D'utilisation

gape, causing the monitor to lose contact with the baby and false alarm. A very 'full' or
wet diaper may also cause it to gape.

6. FITTING YOUR HERO

Ensure that the Battery Cover (9) is secure. Clip your Hero all the way onto the diaper to
the full extent of the clip, as shown:-
Make sure that the Movement Sensor
(1) is in contact with the baby's tummy
around the belly button area, although
closer to the sides may suit different
sleeping positions.
The World Health Organisation (WHO)
recommends that babies be placed to
sleep on their back unless advised
otherwise by a doctor

7. OPERATION

7.1 Startup

Switch on by briefly pressing the ON/OFF button (6).
A startup-test will run which will turn on (in sequence) all indicator lights, vibration
stimulator and audible alarm. The Battery Indicator Light (2) will flash briefly as follows:-
Green Battery OK
Orange Battery nearing depletion – replace battery
Red Battery flat – Hero will not monitor, replace battery
Warning: Ensure that all lights, vibrator and alarm are working properly and that the
battery level is high enough for proper operation (i.e. green or orange light). Otherwise,
DO NOT use the monitor. If the battery is too flat to operate, the Battery Indicator
Light (2) will flash red accompanied by a short beep every second. Change the
battery before further use (see Section 9.3 Replacing the Battery ).
To switch OFF, press both the ON/OFF button (6) and the MODE/OFF button (7)
simultaneously.
7