Rouse Warning; Movement-Rate Warning - Snuza HERO Notice D'utilisation

This feature may be used with a baby sound monitor to enable you to 'hear' baby's
movements from a distance.

8.2 Rouse Warning

During monitoring, if no movement is detected for 15 seconds, Hero vibrates gently in
an attempt to rouse the baby. If movement resumes within the next 5 seconds, the
Movement Indicator Light (3) will flash red on each subsequent movement as an
indication that there has been an incident of no movement for 15 seconds.
With the Rouse Warning enabled, after 3 such vibration/rousing incidents, the
Movement Indicator Light (3) will change to flash red every 2 seconds and Hero will
emit an audible beep every 2 seconds. This alerts you to the fact that your baby has
stopped all movement for 15 seconds on three occasions and has then resumed
movement after Hero has vibrated.
Note:- If movement does not resume within 5 seconds after a vibration, the full audible
alarm will sound and the Alarm Indicator Light (4) will flash red.
The Rouse Warning is automatically enabled each time Hero is switched ON. To disable
this warning, ensure that Hero is switched ON, and press and hold the MODE/OFF
button (7) for at least 1 second until a tone is heard and the unit vibrates briefly.
If you want to enable the warning again, switch Hero off completely (press both ON/OFF
(6) and MODE/OFF (7) buttons simultaneously), then switch it ON again (the rouse
warning is enabled by default when Hero is switched on).

8.3 Movement-Rate Warning

The Movement-rate Warning alerts you if the baby moves less than 8 times per minute
– the Movement Indicator Light (3) flashes orange and the Movement-rate Warning
sounds (dual-tone beep every second). This feature is automatically enabled each time
Hero is switched ON.
To disable this warning during monitoring, ensure that Hero is switched ON, and
press and hold the ON/OFF button (6) for more than 1 second until the unit beeps.
If you want to enable the warning again, switch Hero off completely (press both
ON/OFF (6) and MODE/OFF (7) buttons simultaneously), then switch it ON again.
The Movement-rate Warning is enabled by default when Hero is switched on.
10