Festool CT-F I/M-Set Notice D'utilisation page 34

English
Connecting a remote control to the
mobile dust extractor
If the remote control and the
retrofit receiver module are pro­
vided, the connection between
the devices has been preset and
you can skip this step.
To be able to connect a remote
control to another mobile dust
extractor, the remote control
must be reset (see chapter
"Troubleshooting").
► Activate the mobile dust extractor's
automatic mode.
► Press the connection button on the
retrofit receiver module [2-1] for ap­
34
proximately three seconds until the
LED indicator rapidly starts to flash
[2-2].
The retrofit receiver module is ready for
connection for 60 seconds.
► Follow the instructions provided in
the Festool app.
► Press the MAN button [1-3] on the
remote control.
The remote control is permanently
stored in the retrofit receiver module.
The mobile dust extractor can be
connected to as many as five re­
mote controls at the same time.
Switching on/off
Once the remote control is connected to
the mobile dust extractor, the mobile