Silverline 935328 Mode D'emploi page 10

GB
Troubleshooting
Problem
No function when ON/OFF Trigger
Switch (9) is operated
Slow cutting performance
Saw Blade (1) blunts quickly
10
Possible cause
No power
Defective ON/OFF Trigger Switch
Carbon brushes worn
Saw Blade (1) not suitable for the material being cut
Saw Blade blunt
Incorrect cutting speed
Saw Blade not suitable for the material being cut
Too much pressure exerted on to the tool
Cutting speed too fast
No cutting fluid/cooling agent used when cutting metal
Solution
Check power supply
Have the ON/OFF Trigger Switch replaced by an authorised Silverline service
centre
Have the carbon brushes replaced by an authorised Silverline service centre
Fit compatible saw Blade
Fit new saw Blade
Adjust cutting speed to match material requirements
Fit compatible saw Blade
Use less pressure whilst moving the tool
Reduce cutting speeds to material requirements
Use a suitable cutting fluid when cutting metal