Auto Search; Web Configuration - Velleman CAMIP4 Notice D'emploi

Caméra couleur ip real plug-and-play

Table des Matières

Les langues disponibles

• The initial screen shows the display area(s) (Video). The layout can be changed and set to 1 – 4 –

6 – 9 – 13 or 16 display areas by clicking on the desired icon in the top left corner:

Note: the content (displayed camera) of each area can be set individually.

• The list of available cameras is shown on the left of the screen. When using the software for the

first time, the list will be empty.

7.2 Auto Search

• In order to use Auto Search, a camera must be connected to the same LAN (Local Area Network)

as the computer. Double-click on the Auto Search directory or right-click on Auto Search and

left-click again on Auto search to start searching the network.

Note: be aware that routers or firewalls might prevent the software from seeing the IP-camera. Get

advice from a network administrator when this is the case.

• The software interrogates the local LAN and shows all the found IP-camera IDs (e.g. 001040042)

under the Auto Search directory. Scroll the mouse over the camera ID to see the IP-address.

Note: a camera which is shown under the Auto Search directory is not available worldwide. It must

be moved to the Camera List (see § 7.4) to become accessible from another network.

• Right-click on the camera ID and left-click on Web configure to configure the camera using a

web browser.

Note: when configured in the appropriate way, the IP-camera can be reached from any

computer/web browser in the world. Simply type the IP-address into the address bar of the

web browser and enter the user name and password.

• The browser requires a username and password to set-up the camera. The default user name is

admin, no password required.

• When user name and password are validated, the information page is shown.

17/07/2009

CAMIP4

Rev. 02

Table des Matières