GRAUPNER EUROFIGHTER Mode D'emploi page 16

connect the servo leads to the receiver in the correct sequence, and fix the receiver in
the fuselage nose using double-sided foam tape. Deploy the aerial lead along the
fuselage. We recommend that you use an SPCM receiver in this model. We recommend
the LiPo flight battery Order No. 7643.3. Push it between the fuselage sides as shown in
the photo; it can be moved forward or back to obtain the correct balance point.
Peel off the decals from the backing film and apply them to the model in the
arrangement shown in the kit box illustration.
Control surface travels
Aileron travel relative to centre:
Elevator travel relative to centre:
Neutral position relative to centre:
Nosewheel: travel to suit your preference; plenty of Expo
Centre of Gravity: 305 mm measured from the wing trailing edge
First flight:
- Assemble the model as described in these instructions, program the radio control
system as explained above, and charge all the batteries fully. There is now no excuse
for not flying the model!
- We recommend that you carry out a range check with the motor running before you fly
your new EUROFIGHTER.
- Do not attempt to fly this model unless you are a pilot with at least average flying
skill and experience.
- We recommend a ground take-off, ideally from a smooth asphalt strip. Our test models
lift off after a ground-roll of about fifteen to twenty metres.
- Although the aeroplane is extremely simple to build, it is fairly demanding to fly.
All of us in the Graupner Team hope you thoroughly enjoy building and flying your
EUROFIGHTER.
Yours - the Graupner team
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
+ 22 mm, 10% Expo
- 10 mm, 10% Expo
+ 35 mm, 35% Expo
- 15 mm, 35% Expo
+10 mm
16
09/2008