Lighting Instructions; To Turn Off Gas To Appliance - Emerson White-Rodgers 36H Serie Instructions D'installation

WARNING
!
A. HSI MODELS: This appliance does not have a
pilot. It is equipped with an ignition device which
automatically lights the burner. Do not try to
light the burner by hand.
PROVEN/INTERMITTENT PILOT MODELS:
This appliance is equipped with an intermittent
ignition device which automatically lights the
appliance. Do not try to light the pilot by hand.
B. BEFORE OPERATING smell all around the ap-
pliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and
will settle on the floor.
FOR YOUR SAFETY
"WHAT TO DO IF YOU SMELL GAS"
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
1. STOP! Read the safety information above on this
label.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. HSI MODELS: This appliance is equipped with
an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service
is to be performed.
White-Rodgers is a business
of Emerson Electric Co.
The Emerson logo is a
trademark and service mark
of Emerson Electric Co.
FOR YOUR SAFETY READ BEFORE OPERATING
If you do not follow these instructions exactly, a fire or explosion
may result, causing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

www.white-rodgers.com
www.emersonclimate.com

LIGHTING INSTRUCTIONS

• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to move the gas control
switch. Never use tools. If the switch will not
move by hand, don't try to repair it, call a quali-
fied service technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician
to inspect the appliance and to replace any part
of the control system and any gas control which
has been
under water.
5. PROVEN/INTERMITTENT PILOT MODELS:
This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the burner by hand.
6. Remove control access panel.
7. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow "B" in the safety
information above on this label. If you don't smell
gas, go to the next step.
8. Push gas control switch to "ON."
NOTE: Do not force.
9. Replace control access panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance" and
call your service technician or gas supplier.
3. Remove control access panel.
4. Push gas control switch to "OFF." Do not force.
5. Replace control access panel.