Tips And Tricks For Great Performance; Prepping Your Home Using Botboundary Strips - shark ION ROBOT RV750C Instructions

TIPS AND TRICKS FOR GREAT PERFORMANCE

Your Shark ION ROBOT™ is designed with Smart Sensor technology so it can
navigate around obstructions as it cleans your floor. During your first few
cleanings, you may need to make some small adjustments to optimize your robot's
performance.
CORDS AND OBSTRUCTIONS
Always prep your home before cleaning.
Some furniture or loose cords may create
problems for your robot. Clear away cords
and obstructions or block off the area with
the included BotBoundary™ strips.
LOW-CLEARANCE FURNITURE
Your robot may find its way under furniture
with low clearance, but not be able to free itself.
Use furniture risers to increase clearance, or
create a no-go zone with the included
BotBoundary strips.
DOORWAY THRESHOLDS
Your robot can easily climb over most common
thresholds. However in some situations they
may present a challenge. Use the included
BotBoundary strips to block off these areas.
RETURNING TO DOCK
Make sure the dock is set up as shown.
If your robot roams too far, it could have
trouble finding the dock. It may be helpful to
block off part of your home with the included
BotBoundary strips, or to add a second dock
(available at sharkaccessories.com)
Tip: You can use the included connectors to create angles with your
included BotBoundary strips.
21 21
1-800-798-7398 1-800-798-7398
Before Prep Robot Friendly
1 m
1 m
1.52 m
PREPPING YOUR HOME USING BOTBOUNDARY
Use the BotBoundary strips to quickly and easily create "no-go zones" to keep
your robot out of the areas you would like it to avoid. These may include:
• Near power cords that might cause tangles
• Hallways where you'd rather your robot not travel
• Around furniture with low clearance that may trap your robot
BotBoundary strips
BotBoundary strips
USAGE INSTRUCTIONS
1. Cut the BotBoundary strip to the desired length, (45 cm/ 18" minimum).
The strip must be long enough to cover the entire perimeter of an object
or span the length of the doorway you'd rather your robot not cross.
2. Simply place the BotBoundary strip flat on the floor or under an
area rug. For best results, make sure your BotBoundary strip is
completely flat against the floor.
3. With the provided connectors, you can create angles to
customize the BotBoundary strips to fit your home.
For best results with your BotBoundary strips, use the included
connectors to make a closed loop around an object, or place the strips
between fixed objects, like door frames or the legs of a couch.
NOTE: You do not need to use BotBoundary Strips on stairs.
Your robot has cliff sensors what will prevent from falling off
any cliffs or stairs.
STRIPS
™
(45 cm /18"
Minimum)
Boundary strip lays flat
22
s h a r kc l e a n . c o m s h a r kc l e a n . c o m