Powerfist 8000943 Fiche Technique Et Manuel D'utilisateur page 11

V4.0
REPLACING THE XENON LIGHT BULB
1. Twist the slotted knob on the bottom of the tool's 'barrel' until it comes
loose. It is held in place with two fitted bars and a spring. Use a screw
driver if the knob can't be turned by hand.
2. Remove the Xenon light bulb from the knob by gently pulling it out.
3. Insert new bulb into the knob. Ensure the end enclosed in the metal cup is
inserted into the knob.
4. Insert the bulb into the bottom of the 'barrel' and twist until the knob locks
into place.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
No flash.
No flash but the
check light is on.
Visit www.princessauto.com for more information
Engine Timing Light
Possible Cause(s)
1. The battery clamps are
connected to wrong
battery terminals.
2. Clamps connect poorly to
battery terminals.
1. Inductive clamp is
attached incorrectly.
2. Weak ignition or the spark
plug gap is incorrect.
3. Faulty Xenon light bulb.
Suggested Solution(s)
1. Reverse the battery clip
connections.
2. Clean the battery clamps and
terminals of debris and
corrosion.
1. Attach the inductive clamp
with the arrow pointing
towards the spark plug.
2. Connect clamp to other spark
plug wires and check if the
flash works. If it works, repair
or replace the plug.
3. Replace Xenon light bulb.
8000943
11