Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TECHNICAL DATA

Irreversible gear motor for sliding gates with maximum weight of 1000 Kg. The irreversibil-
ity of this operator arranges that the gate do not need any sort of electric lock for a suc-
cessful closure. The motor is protected by a thermic probe that in case of prolonged use
suspends temporarily the movement.
INSTALLATION SUPER SIM
PRE-INSTALLATION CHECK
- THE GATE MUST MOVE WITHOUT FRICTIONS
ATTENTION: It is obligatory to conform the characteristics of the wing to the laws in vigour.
The wing can be automatized only if it is in good conditions and if it is in conformity with the EN 12604 norm.
The wing must not present pedestrian doors. In contrary case appropriate precautions must be taken according to the point 5.4.1 of the EN
12453 (for example to block the movement of the motor when the wicket door is open, thanks to a micro switch appropriately connected to
the control unit).
You must not produce points of trapping (for example between open wing of the gate and rail fence).
Besides to the limit switches present into the unit, it is necessary the positions of the presence of a fix mechanical stop to each of the two
extreme positions of the course, which stops the wing in case of malfunctioning of the limit switches. To make it possible the mechanical
limit switch must be dimensioned to sustain the static thrust of the motor and the kinetic energy of the wing.
The columns of the gate must have some anti-derailment guides on the upper part to avoid involuntary releasings.
ATTENTION: Remove mechanical stops of the type described in the picture. No mechanical stops must be present at the bottom of the gate be-
cause they are not enough safe.
UNLOCKING SYSTEM WITH LEVER
In case of absence of power supply, the gear motor will be able to be unlocked by turning in clock wise sense the suitable key supplied (right
direction, see picture) and drawing the lever to 90° .
To block the motor, take again the unlocking lever into the initial position and turn it in anti-clock wise sense.
6-1624817 rev.1 24/07/2007
ITA
ENG
FRA
ESP
DEU
POR
Technical data
Power supply
(Vac 50Hz)
Absorption
(A)
Power of the motor
(W)
Maximum weight gate
(Kg)
Capacitor
(µF)
Velocity
(m/min)
Revolutions of the motor (rpm)
Service
(%)
Degree of protection
(IP)
Weight of the operator
(Kg)
Noise
(dBA)
Thermic intervention
(° C)
Velocity idling
(m/min)
Super SIM
230
1.7
330
1000
12.5
10
1400
50
44
10.5
<30
140
10
pag. 3 di 4

Publicité

Table des Matières
loading

Table des Matières