Control Options During Voice Calls - Telecom Behnke 10 Serie Mode D'emploi

▸
Use configuration step code 09 to set the
time interval for relay activation, i.e. the
amount of time (in seconds) the relay will
open the door.
▸ Use Configuration step codes 10 and 11 to
set the activation codes for the relay. If
you change the default activation code in
configuration step code 10 from 0 to e.g. 55,
the relay will be activated to open the door
by entering 55 followed by the # key on your
telephone with DTMF dialling.

5.4. Control options during voice calls

During voice calls, Behnke Series 10 Intercom
stations offer several control options to
be activated using a telephone with DTMF
dialling:
Entry
Activation code #
## x
* #
* *
www.behnke-online.com
Function
Activate the relay
In order for the relay to be activated via an activation code,
the relay operations mode and the activation interval and, of
course, the activation code need to be set accordingly.
Set volume to x (x=0 to 9)
Volume settings apply to the current connection only. In case
the volume is to be changed permanently, please perform confi-
guration steps 06 and 07.
Hang-up
Enter the set-up mode (subsequently enter the security code)
Instructions for Series 10
Operation
GB
51