Telecom Behnke 10 Serie Mode D'emploi page 37

▸ Answer an incoming call
Answer an incoming call either manually by
pressing a button or automatically after the
first recognised signal.
▸ Direct call: Dial a saved telephone number
by pressing the button.
Up to two buttons may be used as direct call
buttons. The telephone number assigned
to these buttons may consist of up to
20 characters. The "pause" function is
assigned a special symbol, which may be
included into the saved telephone number.
The amount of time for the direct call button
to be pressed can be adjusted. By default,
a short touch is sufficient to start a direct
call. Use the option "input delay for direct
call buttons" to set the minimal amount of
time for activation of a direct call button to
values between 0 and 9 seconds.
www.behnke-online.com
Instructions for Series 10
▸ Control functions: automatic or manual
relay activation
The built-in relay enables a variety of
control functions. The operating mode may
be adjusted accordingly. To trigger the relay,
please enter the activation code followed
by the # key. During a connected call, the
activation code may be entered remotely
using a telephone with DTMF dialling. A
maximum of two four-digit activation codes
may be saved. The activation interval may
be set to values between 1 and 30 seconds.
The connection will be terminated after the
relay has been activated, if desired. Upon
establishing connection the activation
interval may be set to values from 1 to 30
seconds.
GB
Introduction
37