Configuration And Set-Up - Telecom Behnke 10 Serie Mode D'emploi

Instructions for Series 10
GB

Configuration and Set-up

configuration and set-uP
4.
Configuration for your new device may be set
remotely using a telephone with DTMF dialling.
To enter set-up mode, please enter the four-
digit security code. The different settings are
changed via configuration step codes with an
individual code for each function to be set.
1 Start set-up mode
Remotely by using a telephone with DTMF
dialling:
▸
Call your Behnke Series 10 Intercom station
▸
The Behnke Series 10 Intercom station will
pick up the call and answer with a beep
▸
Press the * key within two seconds after the
beep (in case more than two seconds elapse
before the * key is pressed, set-up mode
may also be activated by pressing the * key
twice) [beep]
▸
Enter the security code
(default: 0 0 0 0) [beep] [beep]
2 Enter the configuration step code
▸
Enter the configuration step code (cf. table
of configuration step codes) [beep] [beep]
▸
Enter the desired parameter and confirm
with the # key [beep] [beep] [beep]
42
The different configuration steps do not need
to follow a certain order. Entering incorrect
information in set-up mode will result in
a darker, slightly longer error tone. After
the error tone, you may continue set-up by
entering the next configuration step code.
Set-up mode will be automatically terminated
after 30 seconds without entry.
3 Terminate set-up mode
▸
Press the * key or no entry for 30 seconds
www.behnke-online.com