Operation; Dialling A Saved Telephone Number After The Button Has Been Pressed; Calling A Behnke Series 10 Intercom Station; Open The Front Door From The Inside - Telecom Behnke 10 Serie Mode D'emploi

Instructions for Series 10
GB

Operation

oPeration
5.
5.1. Dialling a saved telephone number
after the button has been pressed
The direct call buttons on Behnke Series
10 Intercom stations can be set to dial
a telephone number. To do so, go to the
respective configuration step (direct call
button 1 = configuration step code 21, ...,
direct call button 2 = configuration step code
22) to enter and save the desired telephone
number. Then, your Behnke Series 10 Intercom
station will dial the number saved for the
respective direct call button after it has been
pressed.
Please note:
▸ In case no telephone number has been
assigned to a direct call button, pressing
this direct call button will result in the
intercom station picking up and hanging up
immediately followed by an error tone.
▸
Use configuration step code 04 to set a
minimal amount of time, a direct call button
needs to be pressed for activation to make
the call to the number saved.
▸
The integrated voice message option allows
you to record different voice messages
via configuration step code 58. These
recorded messages can either be played
while establishing a connection to the
remote station or after the remote station
has picked up the call. (Using this option
requires an additional 15 V +/- power
supply.)
50
5.2. Calling a Behnke Series 10 Inter-
com station
To call a Behnke Series 10 Intercom station,
simply dial the telephone number of the
extension the Behnke intercom station is
connected to. As soon as the Behnke intercom
station recognises the incoming call, it
will answer automatically and establish a
connection.
Please note:
▸
Use configuration step code 03 to choose
in which way a call will be answered. If set
to manual connection, a direct call button
needs to be pressed in order to establish a
connection.
5.3. Open the front door from the
inside
When used as a door intercom, the Behnke
Series 10 relay is generally set to hold the
open door function. During a voice call, use a
telephone with DTMF dialling to activate the
relay in order to open the door. To activate
the relay in order to open the door, dial 0 #
from a telephone with DTMF dialling. This
will open the door and the connection will be
terminated.
Please note:
▸
Use configuration step code 08 to choose
the operations mode for the relay. In order
for the relay to open the door, a suitable
operations mode needs to be set, e.g.
operations mode 4.
www.behnke-online.com