Tightening Torques; Note - HanseLifter IMOW-E-BF Serie Mode D'emploi

Replacing safety-relevant components
To detect defects and to ensure safety, some of the parts should be checked on schedule/in due time. The
following parts should be check and replaced based on the respective period of use.
If a part already shows signs of wear and tear early, it should be replaced immediately.
Safety-relevant parts
Brake hoses or pipes
Hydraulic for the lifting system
Lifting chains
High pressure hose, pipe for the hydraulic system
Brake oil tank
Fuel lines
Seals, rubber parts

Tightening torques

Dimension
M 6
M 8
M 10
M 12
M 14
M 16
M 18
M 20
M 22
M 24
M 27
M 30
M 36 882 - 1078

Note:


Only use screws of strength class 8.8 for all load-bearing and other important parts.

The strength classes are listed in the table above
IMOW-E-BF series Any kind of reproduction, even in parts, is not permitted.
Table 6 Period of use
4.6 5.6
4-5 5-7
10-12 12-15
20-25 25-31
35-44 44-54
54-69 69-88
88-108 108-137
118-147 147-186
167-206 206-265
225-284 284-343
294-370 370-441
441-519 539-686
529 - 666 666 - 833
1098 - 1372
Table 7 Tightening torques
Tightening torque (Nm)
6.6
6-8
14-18
29-39
49-64
83-98
127-157
176-216
245-314
343-431
441-539
637-784
784 - 980
1323 - 1677
Period of use (years)
2400h-4800h (1-2)
2400h-4800h (1-2)
4800h-9600h (2-4)
4800h (2)
4800h-9600h (2-4)
4800h (2)
4800h (2)
8.8
9-12
22-29
44-58
76-107
121-162
189-252
260-347
369-492
502-669
638-850
933-1244
1267 - 1689
2214 - 2952
Page 43 of 48