8.12.
DIP A operating logic
The control unit is equipped with a set of microswitches that enable various functions to adapt
the system to the requirements of the user and ensure his safety.
1-OFF 2-ON
3-ON
3-OFF
4-ON
4-OFF
5-ON
5-OFF
6-ON
6-OFF
7-ON
7-OFF
8-ON
8-OFF
9-ON
9-OFF
10 (ON-OFF)
The recommended standard configuration is
1-OFF
2-ON
3-OFF
4-OFF
step-by-step
Activating N.C. keylock electro
function with piston or magnetic
electro
Activating electro lock function
with unhook (code 1122.59)
Man present
Present man disabled
Setting ramps
Advance opening electron lock
N.C.
encoder input
Opening delay
Time and position learning
NORMAL FUNCTION
Step-by-step function enable
Electric lock cod. 1122.59
Man-present mode deactivation
Each command follows the open-stop-
stop-open logic etc...
The output activates half a second
before the start of the sun pit and
remains active for the duration of the
bike, it is deactivated about a second
after the STOP.
The output activates half a second
before the opening of the door and
remains active for two seconds.
The present man mode is activated
(available by adding closing command
on terminal 16 of the control unit)
The present man mode is disabled
Enable acceleration and deceleration
ramps
Turn off acceleration and deceleration
ramps
Attiva pre apertura elettro serratura di 2s
(con DIP 3 su ON)
Disattiva pre apertura elettro serratura di
2s
Posizionare
l'ingresso ENCODER.
Disable ENCODER input
Triggers a 2-second opening delay
when the button is pressed
Disabling function
Not used
-
in
ON
per
abilitare
Page 19