Clearing The Memory - Master FORCE 450 N Manuel D'utilisation Et D'installation

If a piece of rigid wire is used instead of an antenna, it must be cut to 17 cm for the 433Mhz
frequency and connected only to terminal 18.
N.B.: CONNECT THE ANTENNA ONLY AFTER CARRYING OUT THE REMOTE CONTROL
CODE LEARNING PHASE (optional item, 1121.50).
8.10.1. Remote control code learning
This operation is possible only when the automation is in the closed position.
Carry out the code learning phase without connecting the antenna to terminals 17-18
1 To select a channel of the 1122.50 remote control, press the CH key; the displayed
channel flashes. Use the arrow keys ▲(up) or ▼(down) to select the desired channel,
that will begin to flash. Press CH again; the channel will now be on and steady.
2 Press and release the P1 PUSH BUTTON of the control unit; LED L1 will remain lit
for 6 seconds. Then:
3 Then, within these 6 seconds, press the remote control key that will be used as the
START control; it is advisable to choose the ▲(up) arrow
8.10.2.

Clearing the memory

Use the P1 PUSH BUTTON on the board to delete all the remote control codes saved on
the control unit. For this operation, proceed as follows:
1 Press and hold the P1 PUSH BUTTON on the board; LED L1 remains lit
2 After 6 seconds, LED L1 will turn off; at this point, you can release the P1 push button.
LED L1 will immediately give 4 different flashes and then it will flash constantly to
indicate that it is ready to manage the fixed codes. The memory has been
successfully cleared.
N.B.: This operation can be carried out only with the control unit outputs disabled. This
operation is possible only when the automation is in the closed position.
Page 17