Belt Assembly - Master FORCE 450 N Manuel D'utilisation Et D'installation

5.5.3. Belt assembly

The assembly described below shall be carried out with the components included in the bracket
kit (1122.70D and 1122.70S).
Take one of the ends of the belt, attach it to the idler pulley and secure it to the belt tensioner
plate. Carry out the same procedure on the motor side; keep the belt taut and cut off any excess
part as you attach and secure the belt to the belt tensioner.
Page 10
Bracket not included in the kit.
The dimensions of the bracket
vary according to the type
of profile used.