Emptying The Water Tank - ProBreeze PB-AC06 Mode D'emploi

6. Push the water tank back into the unit and
clip the lock back in place.
Note: For cooler air, simply add the
refrigerated, or frozen, ice packs into the
water tank.
Notes:
• If the water level is too low, the
humidification indicator will continue to
flash until the water tank has been refilled
with water.
• Place the ice packs in a freezer for at least
four hours prior to use.
• Do not fill the water tank over the max line
or below the min line.

EMPTYING THE WATER TANK

Due to the large capacity of the water tank it
is recommended to run the appliance until the
water level is at the min line prior to emptying
the water tank.
To empty the tank:
1. Turn off the appliance and unplug it from
the power socket.
2. Place a shallow tray underneath the water
outlet to avoid water spilling onto the floor.
3. Unclip the lock and pull the water tank
out gently with both hands. Caution: the
water tank is connected to the device.
Do not force the water tank out.
4. On the base of the water tank, there is a
clip that connects the filter to the tank.
Turn the clip 90 degrees anticlockwise and
disconnect the filter from the water tank.
5. Empty the water tank into a sink, drain or
other suitable area and dry with a clean,
dry cloth.
6. Re-attach the filter, push the tank back into
the device and clip the lock back in place.
(2,3: Filling the water tank)
3.
(5: Emptying the water tank)
2.
5.
English | 7