Publicité
Les langues disponibles
Les langues disponibles
User Manual of Water-Proof Brushless Speed Controller (RTR Version)
USER MANUAL
WATER-PROOF
SENSORLESS BRUSHLESS
SPEED CONTROLLER
(RTR VERSION)
[DECLARATION]
Thanks for purchasing our electronic speed controller (ESC). The power system for RC model can be very dangerous,
so please read this manual carefully. In that we have no control over the correct use, installation, application, or
maintenance of our products, no liability shall be assumed nor accepted for any damages, losses or costs resulting
from the use of the product.
[FEATURES]
1. Water-proof and dust-proof. The ESC can work under water for a short time.
(Please remove the cooling fan when running car in water, and after running, please make the ESC clean and then
dry it to avoid the oxidation to copper connectors)
2. Specially designed for RC car and truck, with excellent start-up, acceleration and linearity features.
3. Drive sensorless brushless motors.
4. 2 running modes ("Forward with brake" mode, "Forward/Backward with brake" mode).
5. Proportional ABS brake function with 4 steps of maximum brake force adjustment, 8 steps of drag-brake force adjustment.
6. 4 start modes ("Punch") from "Soft" to "Very aggressive" to be suitable for different chassis, tires and tracks.
7. Multiple protection features: Low voltage cut-off protection for Lipo or NiMH battery / Over-heat protection / Throttle signal
loss protection / Motor blocked protection.
8. Easily programmed with the "SET" button on the ESC or with the LED Program Card.
[SPECIFICATIONS]
Model
WP-S16-RTR
WP-S10C-RTR
Cont./Burst
25A/90A
45A/260A
Resistance
0.005 ohm
0.0012 ohm
Car Applicable
1/18,1/16 scale
2S Lipo
On-road: ≥12T
On-road: ≥9T
6 cells
Off-road: ≥18T
Off-road: ≥12T
NiMH
2040 size motor
3650 size motor
Motor
Limit
3S Lipo
On-road: ≥18T
On-road: ≥12T
9 cells
Off-road: ≥24T
Off-road: ≥18T
NiMH
2040 size motor
3650 size motor
Battery
Rating Voltage of
Without cooling
the Stock Cooling
5V
fan
Fan
(*Note1)
Built-in BEC
6V/1A
Program Port
Rx Wire
Dimension/Weight
36*28*21 / 38g
49*34*35/ 75g
* Note1:
1) The cooling fan on the WP-S16-RTR / WP-S10C-RTR / WP-S10D-RTR / WP-S10DS-RTR / WP-S10E-RTR ESC draws
amperage directly from the battery pack, and the 5V fan can only work with a 2S LiPo / 4-6S NiMh battery pack. When using
a 3S LiPo/7-9S NiMH battery pack, then the fan must be changed into a 7.4V/12V one.
2) The cooling fan on the WP-10BL50-RTR / WP-10BL60-RTR ESC is powered by the built-in BEC, so the 5V fan is OK and
there is no need to consider if the input voltage is high or low.
3) In addition, please detach the fan from the ESC when running the vehicle in water/rain.
[BEGIN TO USE THE NEW ESC]
1. Connect the ESC, motor, receiver, battery
and servo according to the following
diagram
"+" and "-" wires of the ESC are connected with the
battery pack, and #A, #B and #C are connected
with the motor wires. The "SET" button is used for
programming the ESC.
The control cable of the ESC (trio wires with black,
red and white color) is connected with the throttle
channel of the receiver (Usually CH2).
The #A, #B, #C wires of the ESC can be connected
with the motor wires freely (without any order). If
the motor runs in the opposite direction, please
swap any two wire connections.
Note: You can use the transmitter to set the
To "Throttle" channel
throttle channel to the "Reverse" direction,
and then the motor will run oppositely. Please
calibrate the throttle range again after changing
the direction of throttle channel.
WP-S10D-RTR
WP-10BL50-
WP-S10E-RTR
WP-S10DS-RTR
RTR
60A/390A
45A/220A
50A/300A
0.0007 ohm
0.0012 ohm
0.0010 ohm
1/10 scale on-road and off-road
On-road: ≥5.5T
On-road: ≥9T
On-road: ≥8T
Off-road: ≥9T
Off-road: ≥12T
Off-road: ≥11T
3650 size motor
3650 size motor
3650 size motor
On-road: ≥8.5T
On-road: ≥12T
On-road: ≥11T
Off-road: ≥13T
Off-road: ≥18T
Off-road: ≥14T
3650 size motor
3650 size motor
3650 size motor
4-9 cells NiMH or 2-3S Lipo
5V
7.4V
5V
6V/2A(Linear Mode)
6V/3A (Switch Mode)
Multiplexed with cooling fan port
WP-S10D-RTR:
49*34*35 / 75g
48.5*38*32 /90g
48.5*38*32 / 90g
WP-S10DS-RTR:
49*32*41 /
Battery + (Red)
Battery - (Black)
Servo
Receiver
SET
Button
Switch
Blue wire "A"
Yellow wire "B"
Brushless motor
Orange wire "C"
Page - 1 -
WP-10BL60-RTR
60A/390A
0.0012 ohm
On-road: ≥5.5T
Off-road: ≥9T
3650 size motor
On-road: ≥8.5T
Off-road: ≥13T
3650 size motor
5V
48.5*38*32 /90g
Publicité
