Rear Panel - Peavey FX 2 Serie Manuel D'utilisation

Rear Panel

CONNECTIONS
Inserts: These jacks are 1/4" Tip/Ring/Sleeve (TRS) connectors that allow external signal processors to
48
be inserted into the Input Channel signal path. Tip=Send; Ring=Return; Sleeve=Ground. One of the on-
board effects processors can be patched to any channel with an Insert.
Line (1/4") Inputs: These jacks are 1/4" balanced (TRS) high-impedance inputs. The tip is the positive input
49
and should be used for unbalanced inputs. It has 20 dB less gain than the XLR input and does not have
phantom power available. The Mic and Line inputs should not be used simultaneously.
Mic (XLR) Inputs: XLR balanced inputs optimized for a microphone or other low impedance source. Pin
50
2 is the positive input. Because of the wide range of gain adjustment, signal levels up to +14 dBu can be
accommodated.
Stereo (1/4") Inputs: These 1/4" unbalanced inputs work as a stereo line input using both jacks or as a
51
mono input if the connection is made to the L/Mono input only.
Group Inserts: These jacks are 1/4" TRS connectors that allow external signal processors to be inserted
52
into the Group signal path. Tip=Send; Ring=Return; Sleeve=Ground. One of the on-board effects proces-
sors can be patched to any Group Insert.
Group Outputs: These Group Outputs feature 1/4" TRS balanced jacks and provide output signal from
53
the Groups. The output level is set by the Group Level faders (26).
Left/Right Outputs: The Left/Right Outputs feature two 1⁄4" TRS Z-balanced jacks and two fully bal-
54
anced XLR outputs. The 1⁄4" outputs can be used with Tip‚ Ring, Sleeve (TRS) balanced or Tip, Sleeve
(TS) unbalanced connectors. The output level is set by the Master Level faders (40). Both outputs can be
used simultaneously.
AUX 1 - 6 Outputs:
55
These AUX Outputs
feature 1/4" TRS
balanced jacks and
provide signal from the
Auxiliary Outputs. The
output level is set by
the AUX Level controls
(19, 20).
Effects 2 Patch Jack:
56
This 1/4" TRS jack
allows the internal
Effects 2 processor to
be patched to an Input
or Group Insert or to an
external device. The tip
carries the input (return)
signal to the compres-
sor and the ring carries
the output (send).
EFX 2 Return Jacks: These 1/4" high-impedance balanced inputs can be used as stereo or individual
57
returns. Designed for effects return, they can also be used as additional stereo inputs. The L/Mono input
provides signal to both inputs if no connector is attached to the Right jack. The tip is the positive input
for both balanced and unbalanced use.
52
53
54
55
60
57
56 58
61
48
49
51
50
59