Dimensions - Peavey FX 2 Serie Manuel D'utilisation

Equivalent Input Noise (EIN)
-129 dBu (Mic input terminated with 150 Ohms)
Crosstalk/Attenuation
Adjacent Input Channels (1 kHz) -70 dB typical
Left to Right Outputs (1 kHz) -70 dB typical
Common Mode Rejection Ratio (Mic Input)
-50 dB minimum (20 Hz to 20 kHz)
-60 dB typical @ 1 kHz
Phantom Power
+48 volts

Dimensions

FX2 16 : 8"h x 19.0"w x 20.25"d on table top
16.7" wide without rack ears
(20.32cm x 48.3cm x 51.44cm on table top)
(42.4cm wide without rack ears)
12RU (20") x 19.0" x 8" in equipment rack;
7" behind rack
(44.3cm x 48.3cm x 20.32cm in equipment rack)
(17.78cm behind rack)
Installation Note, Ventilation:
This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"
Weight
FX2 16: 22 lbs. (10.0 kg)
FX2 24: 25 lbs (11.4 kg)
FX2 32: 30 lbs. (13.6 kg)
Peavey Electronics Corporation • 5022 Hartley Peavey Dr • Meridian, MS 39305
(601) 483-5365 • FAX (601) 486-1278 • www.peavey.com
Mute Button Attenuation (1 kHz) -80 dB typical
Channel Fader Kill (1 kHz) -80 dB typical
Test Conditions: 120 VAC 60 Hz maintained throughout testing
Features and specifications are subject to change without notice.
Signal/Clip Indicators
Yellow: -20 dBu
FX2 24: 8" high x 24.65" wide x 21.25" deep
(20.32cm x 62.6cm x 53.975cm)
FX2 32: 8" high x 32.75" wide x 21.25" deep
(20.32cm x 83.185cm x 53.975cm)
Power Requirements
FX2 16: 100-240 VAC 50/60 Hz 40 watts nominal
FX2 24: 100-240 VAC 50/60 Hz 55 watts nominal
FX2 32: 100-240 VAC 50/60 Hz 60 watts nominal
© 2012 EX000165
Red: 2 dB below clipping