Rear Panel; Power Switch - Peavey MP 600 Mode D'emploi

REAR PANEL

3 2
POWER
This section describes the proper application of AC power to your MP 600. To ensure the safety
of you and your MP 600, please pay close attention to any designated cautions.
1.

POWER SWITCH

Used to turn AC mains power on or off.
2. FUSE
The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE
REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE
EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY. If the amp repeatedly blows
fuses, it should be taken to a qualified service center for repair.
WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS
BEEN DISCONNECTED FROM ITS POWER SOURCE.
3. REMOVABLE AC POWER CORD
This receptacle is for the IEC line cord (included), which provides AC power to the unit.
Connect the line cord to this connector and to a properly grounded AC supply. Damage to
the equipment may occur if an improper line voltage is used. (See voltage marking on unit.)
Never remove or cut the ground pin of the line cord plug. This unit is supplied with a properly
rated line cord. When lost or damaged, replace this cord with one of the proper ratings.
(For UK Only) As the colours of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in your plug, proceed as
follows: • The wire which is coloured green and yellow must be connected to the terminal
which is marked by the letter E or by the earth symbol, or coloured green or green and
yellow. • The wire which is coloured blue must be connected to the terminal which is marked
with the letter N or coloured black. • The wire which is coloured brown must be connected
the terminal which is marked with the letter L or the coloured red.
All manuals and user guides at all-guides.com
1
4
4