Peavey FX 2 Serie Manuel D'utilisation page 23

Front Panel
STEREO INPUT CHANNELS
Mic Gain
14
This control establishes the nominal operating level for the mic input
(XLR) of the channel. The mic gain can be adjusted over a wide range (0
dB – 60 dB) to compensate for soft voices or very loud drums. To maxi-
mize the signal-to-noise ratio, the gain should be set to the proper level,
with the Channel Fader (13) set to ø. The mic gain can be set by pressing
the PFL button (12) and adjusting for ø dB on the output meter. If the clip
LED comes on and remains lit, reduce the gain.
Stereo Gain
15
This control establishes the nominal operating level for the stereo line
inputs (1/4" jacks) of the channel. The Stereo Gain can be adjusted
over a sufficient range (-∞ to +20 dB) to accommodate almost any
input level. It operates in conjunction with the L/R–CH Switch (16) to
route the stereo signal directly to the L/R buses or through the chan-
nel strip.
L/R–CH Switch
16
This switch establishes the routing of the stereo line input (1/4" jacks)
signal. When the switch is out, the stereo line input signal is routed
directly to the L/R buses, bypassing the channel strip. In this mode, the
mic input (XLR) signal is routed through the channel. When the switch is in, the stereo line input signal is
routed through the channel and the mic input signal is disconnected. The signal level is controlled via the
Stereo Gain control (15).
Input Select Stereo-USB Switch
17
This switch selects the input signal that will feed the stereo line input of the second stereo channel.
When the switch is out, the signal from the stereo line inputs is routed to the Stereo Gain control (15).
When the switch is in, the signal from the device connected to either USB port (60-61) is routed to the
Stereo Gain control (15).
Mid EQ
18
In the Stereo Input channels, this active tone control is a bandpass (peak/notch) type that varies
mid-frequency response by ±15 dB at a center frequency of 850 Hz.
MASTER SECTION
Auxiliary Masters 1-4
19
This control sets the output level of the AUX 1-4 mixes and is adjustable from -∞ to +6 dB.
Auxiliary Masters 5-6
20
This control sets the output level of the various AUX 5-6 mixes and is adjustable from -∞ to +6 dB. These
signals are also sent to the EFX1 and EFX2 internal effects processors, respectively.
AFL Switch/AFL-Clip LED
21
This switch directs the post-fader (AFL) signal to the Headphone output (37) and activates the PFL/
AFL LED display. An adjacent red LED illuminates to signify this selection. If AFL is not selected, the LED
functions as a Clip indicator. Selecting AFL allows monitoring of AUX Masters with the full PFL/AFL Level
Display as well as allowing the operator to hear the output.
Stereo Input Channels
ONLY
14
15
2
17
16
3
18
6