Machine Assembly; Mounting Machine To Stand; Mounting Machine To Bench; Machine Inspection - RIDGID 535 Manuel

20.8"
38.1"
Figure 2 – No. 535 Machine Dimensions

Machine Assembly

WARNING
To prevent serious injury, proper assembly of the
Threading Machine is required. The following pro-
cedures should be followed:

Mounting Machine To Stand

1. The machine is designed to mount on the three uni-
versal stands listed below.
Machine Stands
Model No. Cat. No. Description
100A 92457 Universal Leg & Tray Stand
150A 92467 Universal Wheel & Tray Stand
200A 92462 Universal Wheel & Cabinet Stand
Figure 3

Mounting Machine To Bench

1. If a stand is not used, the machine should be mount-
ed to a stable bench. To mount the unit on a bench,
" bolts in holes provided at each corner
use four (4) 5 /
16
of machine base. Base dimensions are shown in
Figure 2 .
WARNING Failure to mount the threading machine to
a stable stand or bench may result in tipping and serious
injury.
535 Manual Pipe and Bolt Threading Machine

Machine Inspection

To prevent serious injury, inspect your Threading
Machine. The following inspection procedures
20.5"
should be performed on a daily basis:
1. Make sure Threading Machine is unplugged and the
(Not Shown)
REV/OFF/FOR
Figure 4 – No. 535 Pipe and Bolt Threading Machine
2. Clean the speed chuck jaws with a wire brush.
3. Inspect the jaw inserts for excessive wear. Refer to the
4. Make sure the foot switch is present and attached to
without a foot switch.
5. Inspect the power cord and plug for damage. If the
6. Inspect the Threading Machine for any broken, miss-
WARNING
directional switch is set to the OFF position (Figure 4) .
Chuck Handwheel
Centering
Device
Self-Opening
Switch
Foot Switch Carriage Handwheel
Maintenance Instructions if they need to be replaced.
the Threading Machine (Figure 4) .
WARNING Do not operate the Threading Machine
plug has been modified, is missing the grounding
pin or if the cord is damaged, do not use the
Threading Machine until the cord has been replaced.
ing, misaligned or binding parts as well as any other
conditions which may affect the safe and normal
operation of the machine. If any of these conditions
are present, do not use the Threading Machine until
any problem has been repaired.
No. 820
Cutter
(Standard)
Quick or
Die Head
No. 341
Reamer
Chip
Pan
Length Gauge
5