Icons; Tool Assembly; Fitting Brushes And Holder; O. D. Deburring Disk - RIDGID 122 Mode D'emploi

122/122XL Copper Cutting and Prep Machines

Icons

Power ON
Power OFF
Selection of appropriate materials and instal-
NOTI E
lation, joining and forming methods is the responsibility of
the system designer and/or installer. Selection of improp-
er materials and methods could cause system failure.
Stainless steel and other corrosion resistant materials
can be contaminated during installation, joining and form-
ing. This contamination could cause corrosion and pre-
mature failure. Careful evaluation of materials and methods
for the specific service conditions, including chemical and
temperature, should be completed before any installation
is attempted.

Tool Assembly

WARNING
To reduce the risk of serious injury during use, fol-
low these procedures for proper assembly.
ON/OFF switch should be OFF and machine un -
plugged before assembly.

Fitting Brushes and Holder

(optional accessory for the 122XL)
1. Mount the fitting brush holder to the side of machine
using provided screws
2. Attach the quick-change collet (Figure 4) to the front
roller shaft extending from machine housing using the
setscrew. Securely tighten with
3. Pull the collar of the collet to unlock and insert the
brush shank, then release the collar to lock. Make
sure the brush is secure. The brush can be replaced
in similar manner.
Set
Screw
Figure 4 – Collet Installed
6
1 / " hex key.
4
Brush
Holder
Brush
Quick-change Collet

O. D. Deburring Disk

(optional accessory for the 122)
1. Hold the O.D. brush shaft stationary by gripping the
flats located near the surface of the housing with a
wrench (Figure 5).
2. Remove the 1 / " nut and washer, and then remove the
2
brush and spacer.
3. With the disk model number (F-4697) recess facing
the machine housing, slide the deburring disk onto the
shaft and replace the brush. Spacer should not be
used when the deburring disk is installed.
Flat
Figure 5 – Installing Deburring Disk
4. Reinstall washer and

Pre-Operation Inspection

WARNING
Before each use, inspect your Copper Cutting and
Prep Machine and correct any problems to reduce
the risk of serious injury from electric shock, entan-
glement, crushing and other causes and prevent
machine damage.
1. Make sure that the copper cutting and prep machine
is unplugged and the ON/OFF switch is in OFF (O)
position.
2. Clean any oil, grease or dirt from the tool including
handles and controls. This aids inspection and helps
prevent the tool or control from slipping from your grip.
Brush
Shaft
Deburring
Disk
(Recess
towards
machine)
1 / " nut and securely tighten.
2
999-998-069.10_REV. C
9 / "
16