B Luetooth C Onnection - Martin Logan Crescendo X Mode D'emploi

2. Plug in your wireless product and press the
Power button. The Wi-Fi Status light will start
rapidly blinking for about 20 seconds while your
wireless product is booting up. If your wireless
product is not configured to connect to your
network, it will continue to blink. If this is the first
time your new wireless product is plugged in,
the Wi-Fi Status light will start pulsing slowly.
If the wireless product is already configured to
connect to a wi-fi network, the button will turn
solid (connected) or blink rapidly (not connected).
3. Once the Wi-Fi Status light starts pulsing slowly,
your wireless product is in Access Point Mode and
ready to connect to your wireless network. Note:
If the Wi-Fi Status light does not pulse slowly, press
and hold the Wi-Fi Setup button for 8 seconds.
You will hear two tones—one at 3 seconds and
another at 8 seconds. After 20 seconds, the Wi-
Fi Status light will begin pulsing slowly to indicate
Access Point mode is ready. At anytime you can
press the button again to cancel the setup mode.
4. Ensure that Wi-fi is enabled on your computer.
Go to your computer's Wi-Fi set up. Select the
Wi-Fi network with "Play-Fi " in the name.
B c
luetooth onnectIon
1 Set your speaker to Bluetooth mode. Use the
speaker's remote control to select Bluetooth,
or repeatedly press the input button on front of
the speaker until the front LED turns blue.
2 Sync the speaker with your digital media
device or computer. Follow the directions that
came with your device/computer.
5. Once your wireless product is selected as the
Wi-Fi network, open your web browser and type
http://192.168.0.1/index.html in the address bar.
You will see a web page from your wireless product.
6. Click on 'Set Up'. A list of wireless networks will
be displayed. Click on the wireless network you
wish to connect to.
7. Enter the password for your wireless network
then click 'Next'.
8. Enter a name for your wireless product and then
click 'Next' to connect your wireless product to
your network.
9. Your wireless product will attempt to connect to
your network. Once the Wi-Fi Status light turns
solid (not blinking), this indicates your wireless
product is connected to your wireless network.
If the Wi button rapidly blinks, setup failed and
should be tried again.
10. Connect your Mac or PC to the same network
as your wireless product. Open your music
application, press the AirPlay icon, and choose
your speaker from the list.
3 Within your music application, you may need
to select the speaker as the output device for
playback.
4 You are now ready to stream music to your
speaker
19