Martin Logan Crescendo X Mode D'emploi page 17

1. For optimal setup conditions place your wireless
product next to your wireless router. The device
can be moved to its final location after wi-fi setup.
2. Plug in your wireless product and press the
Power button. The Wi-Fi Status light will start
rapidly blinking for about 20 seconds while your
wireless product is booting up. If your wireless
product is not configured to connect to your
network, it will continue to blink. If this is the first
time your new wireless product is plugged in,
the Wi-Fi Status light will start pulsing slowly.
If the wireless product is already configured to
connect to a wi-fi network, the button will turn
solid (connected) or blink rapidly (not connected).
3. Once the Wi-Fi Status light starts pulsing slowly,
your wireless product is in Access Point Mode and
ready to connect to your wireless network. Note:
If the Wi-Fi Status light does not pulse slowly, press
and hold the Wi-Fi Setup button for 8 seconds.
You will hear two tones—one at 3 seconds and
another at 8 seconds. After 20 seconds, the Wi-
Fi Status light will begin pulsing slowly to indicate
Access Point mode is ready. At anytime you can
press the button again to cancel the setup mode.
Android Device Users:
a) Launch the DTS Play-Fi
b) The app will automatically find your device
and provide prompts for setup.
c) Touch the "Setup" button on the screen.
d) Enter the password for your wireless network;
the app will connect your device to your
network. You will notice the Wi-Fi Status light
will have changed from blinking to solid. This
may take up to a minute. If, after a minute,
the button continues to blink rapidly, setup
failed and you should try again.
e) Your wireless product is now connected to
your wireless network. Reconnect your mobile
device to your wireless network. You may re-
name your device using the app.
app.
®
iOS Device Users:
Please note: When using an iOS device your
wireless product can stream audio using either
Apple AirPlay or DTS Play-Fi.
a) Make sure your iOS device's Wi-Fi is turned
on and connected to your Wi-Fi network.
b) Open your iOS device's 'Settings' app
and go to the 'Wi-Fi' menu. Your wireless
product will show up under the heading '
A p
up new ir lAy speAker
c) Select your wireless product from the list. It
will have "Play-Fi " in the name.
d) Once in the 'AirPlay Setup' menu you will
be prompted to select your Wi-Fi network
and name your speaker (you will not need
to enter your network password.)
e) Once your device is connected, you will
notice that the Wi-Fi Status light on your
wireless product will change from blinking to
solid. This may take up to a minute. If, after a
minute, the button continues to blink rapidly,
setup failed and you should try again.
f) Your wireless product is now connected to
your wireless network. Reconnect your iOS
device to your wireless network.
PC Users:
a) Launch the DTS Play-Fi app.
b) The app will automatically find your device
and provide prompts for set up. If the app
does not prompt you to set up a new device,
within the app go to the settings screen and
click 'Setup Play-Fi Device'. Follow the on-
screen instructions.
c) Click the "Set-up" button on the screen.
d) Select the speaker(s) you want to set up.
e) Enter the password for your wireless network;
the app will connect your device to your
network. You will notice the Wi-Fi Status light
will have changed from blinking to solid. This
may take up to a minute. If, after a minute,
the button continues to blink rapidly, setup
failed and you should try again.
set
...'
17