Ryobi ART-3 Manuel D'utilisation page 7

GB
FR DE ES
FEATURES
UNDERTABLE GUARD
Ensures that your hands, loose clothing, and other
objects do not come in contact with the cutter or collet
during operation.
WARNING
The undertable guards must be securely in place
before using the router table. Failure to do so
could result in serious personal injury.
CAUTION:
Keep the cord away from the router table surface
and position the cord so that it will not be caught
on lumber, tools, or other objects during routing.
SAFETY GUARD
Provides a barrier to protect the operator from careless
contact with the cutter. The safety guard is adjustable for
all types of cuts and materials.
The safety guard will slide-up when the work piece is
Q
pushed into the guard.
LIVE TOOL INDICATOR
This tool features a live tool indicator (9) which illuminates
as soon as the tool is connected to the supply. This warns
the user that the tool is connected and will operate when
the switch is pressed.
DESCRIPTION
1. Fence assembly
2. Die cast aluminium table
3. Table leg
4. Switch box assembly
5. Under table guard
6. Mitre gauge
7. Safety guard
8. Throat plates
9. Live Tool indicator
10. Switch
11. Pressure clamp
12. Feather board
13. Step riser
14. Sleeve
15. Bit Storage
IT NL PT DK SE FI NO RU PL CZ
English
SPECIFICATION
Table Dimensions
Extension Table
Safety Guard / Dust Hook-up
Maximum Cutter Depth
Table Height
Mitre Slot
Weight
ASSEMBLY
LEG ASSEMBLY (Fig. 1)
Place router table upside down on a flat, level surface,
Q
so that the front edge is closest to you. Position legs
as shown.
Align the four holes in each leg with the four
Q
corresponding threaded holes in each corner of the
table.
SWITCH BOX ASSEMBLY (Fig. 2)
Hold the switch box so that the words ON ("I") and
Q
OFF ("O") are aligned vertically (On 'on top' Off
'below').
Carefully screw the switch box underneath the router
Q
table with the screws provided.
BIT STORAGE ASSEMBLY (Fig. 3)
Carefully screw the bit storage underneath the router
Q
table with the screws provided.
You can store the router bits in the storage. Hole
Q
diameter is 8mm / 5/16"
UNDERTABLE GUARD ASSEMBLY (Fig. 4)
Locate the undertable guard. Position around the
Q
throat of the table so that the three holes of the guard
line up with the three threaded holes in the table and
securely attach using bolts provided.
FENCE ASSEMBLY (Fig. 5)
Turn the fence assembly over and locate the four
Q
small circular tabs. Position the fence on the router
table so that the tab engage on each channel of the
table.
Locate the two nuts and fence lock knobs.
Q
Position a square nut inside the channel located
underneath the table. Insert the lock knob through
the hole in the fence assembly and screw it into the
square nut below. Repeat for the other side.
3
HU RO LV LT EE HR SI SK GR TR
610 x 355mm
355 x 200mm
ø 57mm
37.9mm
450mm
6.5 x 16 x 610mm
16kg