Use Of Diamond And Hard Metal Drill - SciCan STATIS ML Mode D'emploi

4 Installation and commissioning

Use of diamond and hard metal drill

WARNING! Risk by using wrong drills!
The use of wrong drills may lead to damages of the tooth.
 Use drills as intended.
 Follow manufacturer's instructions for use.
 Use only drills made of steel and tungsten carbide, whose shafts comply with standard ISO 1797-1, type 3 and fulfil the following criteria:
– Diameter 1.59 - 1.60 mm,
– Total length up to 25 mm,
– Shaft clamping length at least 11 mm,
– Cutting diameter up to a maximum of 2 mm.
 Never use drills with worn shafts. They could fall out during treatment and cause injuries.
Page 24 STATIS EN