USRobotics USR9110 Guide D'installation page 21

how to change this setting.
Note: Ad hoc mode is used for peer-to-peer network configurations.
Infrastructure mode is used for integrated wireless and wired LAN
configuration.
My computer does not recognise the wireless function of the Wireless
54Mbps ADSL Router after I changed the settings.
Possible Solution:
Ensure that you are connecting to the correct Wireless 54Mbps ADSL Router by verifying
the correct MAC address. Ensure that the correct passphrase and encryption option is
being used. If you changed the settings in the configuration of the Wireless 54Mbps
ADSL Router, you must also change the settings of every Wireless adapter attached to
this network. The settings of the Wireless adapters must match the new settings of the
Wireless 54Mbps ADSL Router.
I cannot achieve 54 Mbps connections to the Wireless 54Mbps ADSL Router.
Possible Solution:
Make sure the wireless products you are using to connect to the Wireless 54Mbps ADSL
Router support 54 Mbps speeds. 54 Mbps wireless products must be used in order to
connect to the Wireless 54Mbps ADSL Router at a rate of 54 Mbps. Launch the router's
Web User Interface and manually set the connection speed to 54 Mbps.
Possible Solution:
Low connection speed or range can also be caused by environmental interference. Try to
move the product around to improve the link quality. In addition, keep in mind that other
factors such as lead based paint, concrete walls, and electronic items such as 2.4G
phones may affect your wireless range.
I plugged in the 802.11g 54Mbps USB Adapter but I do not see the
Configuration Utility icons.
Possible Solution:
If you installed the 802.11g 54Mbps USB Adapter without installing the software and
17