USRobotics USR9110 Guide D'installation page 20

Possible Solution:
Make sure that your computer is using an IP address that is within the default range of
192.168.2.xxx. Make sure the address of the subnet mask is 255.255.255.0. The Default
Gateway should be the IP address of the Wireless 54Mbps ADSL Router, which is
192.168.2.1. To verify all of these settings, perform the following steps:
Windows 95, 98, or Me Users: Click Windows Start and then Run. Type
winipcfg and click OK. Check the IP Address, Subnet Mask, Default Gateway,
and DNS server data to make sure they are correct. If the information is not
correct, click Release All and then click Renew All.
Windows NT, 2000, or XP Users: Click Windows Start and then Run. Type cmd
and click OK. At the DOS prompt, type ipconfig /all. Check the IP Address,
Subnet Mask, Default Gateway, and DNS server data to make sure they are
correct. If the information is not correct, type ipconfig /release and press
ENTER. Then, type ipconfig /renew and press ENTER.
My Web User Interface for the Wireless 54Mbps ADSL Router is not
responding, but I can still access the Internet.
Possible Solution:
If your Web User Interface stops responding, unplug and then plug back in the power
supply of the Wireless 54Mbps ADSL Router. This will reboot the Wireless 54Mbps ADSL
Router. If you are still unable to communicate with the router's Web User Interface, use a
paperclip to press in and hold the RESET button for five seconds. This will reset the
Wireless 54Mbps ADSL Router to the factory default settings. If you applied any personal
configuration settings, you will need to make the changes again.
I am unable to connect to the wireless function of the Wireless 54Mbps ADSL
Router.
Possible Solution:
Be certain that you have each Wireless adapter is set to Infrastructure mode. If your
802.11g 54Mbps USB Adapter is set to Ad hoc mode, you will not be able to use the
wireless function. Refer to the Navigating the Wireless Configuration Utility chapter of
the 802.11g 54Mbps USB Adapter User Guide on the Installation CD-ROM to determine
16