Camille Bauer EMMOD206 Mode D'emploi page 17

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions
Extension module M-Bus
for A2xx devices
EMMOD206
Camille Bauer AG
Aargauerstrasse 7
CH-5610 Wohlen/Switzerland
Phone +41 56 618 21 11
Telefax +41 56 618 35 35
info@camillebauer.com
www.camillebauer.com
The instruments must only be
disposed of in the correct way!
Safety notes
The installation and commissioning should only be carried
out by trained personnel.
Check the following points before commissioning:
- that the maximum values for all the connections are not exceeded, see
the "Technical data" section,
- that the connection wires are not damaged, and that they are not live
during wiring.
The instrument must be taken out of service if safe operation is no lon-
ger possible (e.g. visible damage). In this case, all the connections must
be switched off. The instrument must be returned to the factory or to an
authorized service dealer.
Do not touch the printed circuit or contacts! Electrostatic
charge can damage electronic components.
Unauthorized repair or alteration of the unit invalidates the warranty.
Contents
1. Brief description .........................................................................................18
2. Scope of delivery ........................................................................................18
3. Technical data ............................................................................................18
4. Block diagram ............................................................................................18
5. Assembly / disassembly .............................................................................18
6. Connections of the device..........................................................................19
7. Display and operating elements .................................................................19
8. Programming ..............................................................................................20
9. M-Bus specification ...................................................................................22
10. M-Bus protocol ..........................................................................................22
11. Switching to Modbus .................................................................................24
12. Conformity declaration ..............................................................................24
EMMOD206 Bdfe
169 335
01.13
17

Publicité

Table des Matières
loading

Table des Matières