Electrical Connection - AEG FAVORIT 55010 VI Notice D'utilisation

52

Electrical connection

2. Connect the water drain hose to a stand pipe with vent-hole (minimum internal di-
ameter 4 cm).
The waste connection must be at a maximum
height of 60 cm from the bottom of the dish-
washer.
Make sure that the drain hose is not bent or
squashed to prevent that the water drains does not
drain correctly.
Remove the sink plug when the appliance drains
the water to prevent that the water goes back into
the appliance.
The total length of the drain hose, extension in-
cluded, must not be longer than 4 m. The internal
diameter must not be smaller than the diameter
of the hose
If you connect the water drain hose to a trap spi-
got under the sink, remove the plastic membrane
(A). If you do not remove the membrane, remain-
ing food can cause a blockage in the drain hose
spigot
The appliance has a security feature to prevent
that dirty water goes back into the appliance. If,
the spigot of the sink has a 'non-return valve', this
valve can cause the appliance to drain incorrectly.
Remove the non-return valve.
CAUTION!
Make sure that the water couplings are tight to prevent water leakage.
Electrical connection
WARNING!
The manufacturer is not responsible if you do not follow these safety precautions.
Ground the appliance according to safety precautions.
Make sure that the rated voltage and type of power on the rating plate agree with the
voltage and the power of the local power supply.
Always use a correctly installed shockproof socket.
Do not use multi-way plugs, connectors and extension cables. There is a risk of fire.
Do not replace the mains cable yourself. Contact the Service Force Centre.
Make sure that the mains plug is accessible after installation.
Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.