To Activate The Rinse Aid Dispenser - AEG FAVORIT 55010 VI Notice D'utilisation

Activate or deactivate the multitab function before the start of a washing programme.
You cannot activate or deactivate the multitab function when the programme operates.
Cancel the washing programme, then set the programme again.
To activate the multitab function:
• Press and hold the two multitab buttons (function buttons D and E). The multitab indi-
cator light comes on.
To deactivate the multitab function:
• Press and hold the two multitab buttons (function buttons D and E). The multitab indi-
cator light goes off.
Do these steps if the drying results are not satisfactory:
1. Fill the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
• You can only activate or deactivate the rinse aid dispenser when the multitab function
is activated.

To activate the rinse aid dispenser

1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons A, B, and C start to flash.
4. Press function button B.
– The indicator lights for function buttons A and C go off.
– The indicator light for function button B continues to flash.
5. Press function button B again.
– The end-of-programme indicator light comes on.
6. Switch off the appliance to save the operation.
To deactivate the rinse aid dispenser do the above steps until the end-of-programme in-
dicator light goes off.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid dispenser.
3. Adjust the water hardness setting to the highest level.
4. Do a washing programme without dishes.
5. Adjust the water softener to the water hardness in your area.
6. Adjust the rinse aid dosage.
Multitab function
43