Parts And Controls - Bushnell PRIME L20 TRAIL CAMERA Manuel D'instructions

INTRODUCTION
About the Prime L20 Trail Camera
The Bushnell Prime L20 Trail Camera is a digital scouting camera. It
can be triggered by any movement of game in a location, detected by
a highly sensitive Passive Infra-Red (PIR) motion sensor, and then take
high quality pictures (up to 20MP still photos), or 720p HD video clips.
The Prime L20 Trail Camera consumes very little power (less than 0.08
mA) in a stand-by (surveillance) state. This means it can deliver up to
twelve months stand-by operation time when the device is powered
by six AA alkaline batteries. Once motion in the monitored area is
detected, the digital camera unit will be triggered at once (typically
less than half a second) and then automatically take images according
to previously programmed settings. The Prime L20 Trail Camera is
equipped with built-in infrared LEDs that function as a flash, so that it
delivers clear photos or videos (in black & white) even in the dark, and
it can take color photos or videos under sufficient daylight. The Prime
L20 Trail Camera is designed for outdoor use and is resistant against
water and snow.
Applications
The Prime L20 Trail Camera can be used as a trail camera for hunting
or scouting game. It is also suitable for surveillance usage.

PARTS AND CONTROLS

The Prime L20 Trail Camera provides the following connections for
external devices: USB port and SD card slot (Fig. 4).
A 3-way power switch is used to select the main operating modes:
OFF, AIM, and ON (Fig. 3).
A D-Pad interface with 5-way keys is primarily used in AIM mode
to select operational functions and parameters. As shown in Fig. 3,
these keys are: UP, DOWN, and OK. Two of the keys can also perform a
second function (shortcut operations in AIM mode) in addition to their
main function: The DOWN key can be used to set the camera to Photo
mode (still camera icon), and the UP key can set the camera to Video
mode (movie camera icon).
3