Mounting And Positioning - Bushnell PRIME L20 TRAIL CAMERA Manuel D'instructions

Restore Default Settings (initialize camera setup)
The display will show "dEFN". To return the Interval, Capture Mode, and
Camera ID# to their original, "factory default" settings, use UP/DOWN
to change the "N" after "dEF_" to "Y" (Yes), then press OK to confirm.
Note: your time and date settings and camera ID# will not be changed
from their current settings to the original defaults, and your SD card will
not be formatted. Only the Interval and Capture Mode settings will be
restored to their defaults.

MOUNTING AND POSITIONING

Mounting
After you've set up the camera's parameters to your personal
preferences at home or in your truck, you're ready to take it outside and
slide the power switch to "ON". When setting up the Prime L20 Trail
Camera for scouting game or other outdoor applications, you must
be sure to mount it in place correctly and securely. We recommend
mounting the Prime L20 Trail Camera on a sturdy tree with a diameter
of about 6 in. (15cm). To get the optimal picture quality, the tree should
be about 16-17 ft. (5 meters) away from the place to be monitored, with
the camera placed at a height of 3.5-5 ft. (1~1.5 m). Also, keep in mind
that you will get the best results at night when the subject is within
the ideal flash range, no farther than 100' (30m) and no closer than 10'
(3m) from the camera.
There are two ways to mount the Prime L20 Trail Camera: using the
provided adjustable web belt, or the tripod socket.
Using the adjustable web belt: Fig. 5 illustrates using the web belt
on the Prime Trail Camera. Push one end of the belt through the two
brackets on the back of the Prime Trail Camera. Thread the end of the
strap through the buckle. Fasten the belt securely around the tree trunk
by pulling the end of the strap firmly so there is no slack left.
Belt Channel
Fig. 5: Attaching the Belt
Strap Buckle
12