Product Installation - brondell CIRCLE RC100 Manuel Du Propriétaire

PRODUCT INSTALLATION

STEP 1: FAUCET INSTALLATION
Top Spout
Top Cap
Main Body
Escutcheon
Lock Washer
Locking Nut
1/4" Tube
(connected to faucet)
1. Unpack the faucet and insert the Top Spout into the Main
Body by pushing down until inserted then screw the Top Cap
clockwise until secured in place.
2. Cut zip tie on the blue water connection tubing and unroll
to straighten tubing. Be careful not to cut the tube when
removing the zip tie.
Before Installation
You will need an existing faucet hole at least 7/16
inches in diameter in the sink or countertop to install
the supplied filtered water faucet. You may also
replace an existing kitchen sprayer, soap dispenser,
or plug already on the countertop or sink.
LED Display
Battery Seat
Battery
(CR2032)
Counter Top
Plastic Washer
If drilling a new hole is required for the
faucet installation, please consult a
professional. Brondell will not be liable for
any damages including those to the sink
or countertop due to installation of the
faucet or drilling a hole.
1
7