brondell CIRCLE RC100 Manuel Du Propriétaire page 15

STEP 4: FINISHING UP
1. Connect the tubes:
a. Connect the open end of the 1/4 inch blue tubing (from
faucet) to the top of the Circle by pushing into the middle
hole labeled "Outlet".
b. Connect the open end of the white tubing (from the drain
clamp) to the top of the Circle by pushing into the hole
labeled "Drain".
c. Finally, connect the open end of the orange tubing (from
the water supply T-valve) to the top of the Circle by
pushing into the hole labeled "Inlet".
d. Be sure to push the ¼" tubing firmly into place to secure.
2. Turn on Water and Check for Leaks
a. Open the T-valve by turning the valve arm 90° and turn
cold water supply back on under the sink at the wall. The cold
water supply will then begin to supply water to the Circle.
b. After turning on the water supply, check all connections for
leaks. Wait 5 minutes and check once more for leaks before
proceeding to the next step.
Failure to properly install this product or to properly
check for leaks may cause damage to the property.
In these instances, Brondell, Inc. will not be held
responsible for any damages.
1
Outlet
Drain
2
Inlet
13