Arsenic Facts - brondell CIRCLE RC100 Manuel Du Propriétaire

CIRCLE FILTRATION SYSTEM PERFORMANCE DATA SHEET
•
For parts and service availability, please contact Brondell at 888-542-3355.
•
This system has been tested for the treatment of water containing pentavalent arsenic (also know as As(V),
As(+5), or arsenate) at concentrations of 0.050 mg/L or less. This system reduces pentavalent arsenic, but
may not remove other forms of arsenic. This system is to be used on water supplies containing a detectable
free chlorine residual at the system inlet or on water supplies that have been demonstrated to contain only
pentavalent arsenic. Treatment with chloramines (combined chlorine) is not sufficient to ensure complete
conversion of trivalent arsenic to pentavalent arsenic. Please see the Arsenic Facts section of this Performance
Data Sheet for further information.
•
Efficiency rating means the percentage of the influent water to the system that is available to the user as
reverse osmosis treated water under operating conditions that approximate typical daily usage.
•
The product water should be tested every 6 months to ensure that the contaminants are being reduced
effectively. For any questions, please contact Brondell toll free at 888-542-3355.
•
This reverse osmosis system contains a replaceable treatment components, critical for the effective reduction of
total dissolved solids and that product water shall be tested periodically to verify that the system is performing
properly. Replacement of reverse osmosis component should be with one of identical specifications, as defined
by the manufacturer, to assure the same efficiency and contaminant reduction performance.
•
The estimated replacement time of filter, which is a consumable part, is not an indication of quality guarantee
period, but it means the ideal time of filter replacement. Accordingly, the estimated time of filter replacement
may be shortened in case it is used in an area of poor water quality.
Part Number
RF-20
RF-40
* The filter replacement cycle may be reduced for areas with poor water quality or greater use.
* The period for the filter exchange is based on an average production of 2.6 gallons of drinking water per day.
Arsenic (abbreviated As) is found naturally in some well water. Arsenic in water has no color, taste or odor. It must
be measured by a lab test. Public water utilities must have their water tested for arsenic. You can get the results
from the water utility. If you have the own well, you can have the water tested. The local health department or the
state environmental health agency can provide a list of certified labs. Information about arsenic in water can be
found on the Internet at the US Environmental Protection Agency website: www.epa.gov/safewater/arsenic.html
There are two forms of arsenic: pentavalent arsenic (also called As(V), As(+5), and arsenate) and trivalent arsenic
(also called As(III), As(+3), and arsenite). In well water, arsenic may be pentavalent, trivalent, or a combination of
both. Special sampling procedures are needed for a lab to determine what type and how much of each type of
arsenic is in the water. Check with the labs in the area to see if they can provide this type of service.
Reverse osmosis (RO) water treatment systems do not remove trivalent arsenic from water very well. RO systems
are very effective at removing pentavalent arsenic. A free chlorine residual will rapidly convert trivalent arsenic
to pentavalent arsenic. Other water treatment chemicals such as ozone and potassium permanganate will also
change trivalent arsenic to pentavalent arsenic. A combined chlorine residual (also called chloramine) may not
convert all the trivalent arsenic. If you get the water from a public water utility, contact the utility to find out if free
chlorine or combined chlorine is used in the water system.
The RC100 system is designed to remove pentavalent arsenic. It will not convert trivalent arsenic to pentavalent
arsenic. The system was tested in a lab. Under those conditions, the system reduced 0.050 mg/L pentavalent
arsenic to 0.010 mg/L (ppm) (the USEPA standard for drinking water) or less. The performance of the system may be
different at the installation. Have the treated water tested for arsenic to check if the system is working properly.
The RO component of the RC100 system must be replaced every 24 months to ensure the system will continue to
remove pentavalent arsenic. The component identification and locations where you can purchase the component
are listed in the installation/operation manual.
Filter Name
Sediment Filter
Pre-Carbon Plus Filter
Post Carbon Block Filter
RO Membrane Filter

ARSENIC FACTS

Usable period
6 months
6 months
6 months
24 months
23