brondell CIRCLE RC100 Manuel Du Propriétaire page 20

FILTER REPLACEMENT (cont.)
HOW TO REPLACE THE FILTERS (cont.)
9. Flush the new filters and the system thoroughly with the
following steps.
a. Turn the provided faucet on all the way for 10 minutes to
purge all the air out of the system.
b. After the initial 10 minute purge, turn the provided faucet
off and let the system run for 40 minutes to allow the
water tank to fill.
c. After 40 minutes, then turn the faucet on all the way once
more for 10 minutes (or until the tank empties) to flush the
filters and the water tank.
d. Turn the faucet off.
e. The tank will fill again in approximately 40 minutes, and
then filtered water is ready to drink.
10. Replace the battery in the faucet LED indicator to reset the
filter change reminder. The battery type is CR2032 and
Brondell provides one with every set of RF-20 filters.
a. Under the faucet handle, locate the black rubber battery
compartment. Grasp it from the sides and pull down as
shown.
b. Remove the old battery from the compartment by lifting
the silver metal tab and sliding the battery out of the
rubber casing. Wait 30 seconds for the residual energy to
drain to reset the indicator.
c. Replace with a new CR2032 battery by sliding the battery
under the silver tab, making sure that the words on the
battery are facing out. A fresh CR2032 battery comes with
every RF-20 Replacement Filter pack.
d. Push the black rubber battery compartment back up into
the faucet handle.
18
9
10a
10c
10d